How's my timming look?

Wanted to see if you think my timming looks? I can't seem to get past 500mhz

AMD 3700 SD w/ AC 64PRO Cooler
MSI NEO2 Platinum BIOS 1.C3 (didn't care for 1.8)
G.Skill 2GB HZ DDR500 (2 X 1GB kit)
ATI X850PRO
WD 74GB Raptor on SATA3

Memory Timings
CAS Latency (CL) 3T
RAS To CAS Delay (tRCD) 5T
RAS Precharge (tRP) 5T
RAS Active Time (tRAS) 10T
Row Cycle Time (tRC) 12T
Row Refresh Cycle Time (tRFC) 24T
Command Rate (CR) 2T
RAS To RAS Delay (tRRD) 2T
Write Recovery Time (tWR) 3T
Read To Write Delay (tRTW) 4T
Write To Read Delay (tWTR) 2T
Write CAS Latency (tWCL) 1T
Refresh Period (tREF) 200 MHz 7.8 us
DQS Skew Control Disabled
DRAM Drive Strength Normal
DRAM Data Drive Strength 4 (No Reduction)
Max Async Latency 7 ns
Read Preamble Time 5.5 ns
Idle Cycle Limit 16
Dynamic Idle Cycle Counter Enabled
Read/Write Queue Bypass 8
Bypass Max 4
32-byte Granularity Disabled

Error Correction
ECC Supported, Disabled
ChipKill ECC Supported, Disabled
RAID Not Supported
DRAM Scrub Rate Disabled
L1 Data Cache Scrub Rate Disabled
L2 Cache Scrub Rate Disabled

Memory Slots
DRAM Slot #1 1024 MB (PC4000 DDR SDRAM)
DRAM Slot #2 1024 MB (PC4000 DDR SDRAM)

loosen up MAL and RP to like 10 and 7.0, then loosen ICL to like 256. then tighten CR to 1t and tRCD and tRP to 4. then change tRFC to 22.

ill need some advise on this kind of stuff soon. But first a need a little modding to get me some volts!

CCUABIDExORxDIE said:

loosen up MAL and RP to like 10 and 7.0, then loosen ICL to like 256. then tighten CR to 1t and tRCD and tRP to 4. then change tRFC to 22.

Click to expand...

And download A64Info and stop posting that hard to read stuff.
http://www.xtremesystems.org/forums/showthread.php?t=96678

billb said:

And download A64Info and stop posting that hard to read stuff.
http://www.xtremesystems.org/forums/showthread.php?t=96678

Click to expand...

that stuff is not hard to read. if its hard to read. i feel bad for your rig and its lack of fully tweaked memory timings. is FSB and HTT and LDT hard to read too??

billb said:

And download A64Info and stop posting that hard to read stuff.
http://www.xtremesystems.org/forums/showthread.php?t=96678

Click to expand...

I thought it was laid out very well.