Watercooling Setup. Need Advice

[CJPC]

Ok Here are my plans:

T-Bird 1.2 ( Hand Picked 119.00, Newegg 96 + Shipping)

K7T266-RU V 2.0 (MSI 6380 V2.0 ) W/ USB 2.0 AND SMARTKEY (http://www.msi.com.tw/products/mainboard/mainboard.php?model=MS-6380+V2.0)

Water Reservoir W/ Pump from 2CoolTek 3/8Th Fittings - 45.00 (http://2cooltek.safeshopper.com/10/193.htm?760)

MAZE2 From Danger Den-42.00 (http://www.dangerden.com/test/mall/maze2.asp)

Which Radiator should I get?

Heater Core from Danger Den -35.00 (http://www.dangerden.com/test/mall/radiators.asp)

OR

Radiator from 2CoolTek-30.00 (http://2cooltek.safeshopper.com/10/176.htm?760)

OR

Something at a junkyard?


Thanks for any and all advice!!


CJPC

[ButcherUK]

Get the heater core.
Also you might consider a more powerful pump, a rio 180 is pretty weak.

[CJPC]

Ok, thanks!

How about The Aluminum water tank& pump from Leufken Technologies? (http://www.leufkentechnologies.com/watercooling.shtml)

:Aluminum water tank with inline AquaVia 200 GPH pump. Fully assembled. Air and water tight. Includes 3/8" brass barbs. Comes with o-ring seal and hardware. $ 49.00

[ButcherUK]

I'd suggest going 1/2" all over and getting an inline pump / res setup as inline pumps tend to give lower temps. A danner magdrive or an eheim is a good choice for inline pumps and cost a similar price to that leufken one.

[The Overclocker]

also be cooling are doing a aluminum res and high power pump at www.aquastealth.com

[CJPC]

How about the ViaAqua 480 at Leufken (http://www.leufkentechnologies.com/watercooling.shtml)

ViaAqua 480. This is an inline 'mag drive' TRUE 200GPH pump. 3/8" barbs (for 1/2" hose). 110vAC. Makes zero noise, runs very cool. Draws about 4.6 watts.


$21.00

Thanks for replies!!