is this a good setup

[ALiEN2953]

so i plan on getting WC, mainly for my ultra hot 7900gt (90C load). and wanted to know if all these were good choices(all use 1/2).

Pump - Swiftec MCP655
GPU block - Swifttec MCW60-B
CPU Block - Swiftec Storm extreme Rev.2
Radiator - recomend one!!! 2x120
Fans - 2x http://www.sidewindercomputers.com/de12ff.html Delta 150CFM
tubing - Tygon 1/2in
Reservoir - http://www.frozencpu.com/ex-res-10.html


PS. how many feet of tubing should i get?

[SiGfever]

so i plan on getting WC, mainly for my ultra hot 7900gt (90C load). and wanted to know if all these were good choices(all use 1/2).

Pump - Swiftec MCP655
GPU block - Swifttec MCW60-B
CPU Block - Swiftec Storm extreme Rev.2
Radiator - recomend one!!! 2x120
Fans - 2x http://www.sidewindercomputers.com/de12ff.html Delta 150CFM
tubing - Tygon 1/2in
Reservoir - http://www.frozencpu.com/ex-res-10.html


PS. how many feet of tubing should i get?
Yes
Yes or Mp-1
Yes
PA120.2 rad
two Yate Loon fans in a pull configuration
7/16" Tygon or MasterKlear tubing 15-20ft
Swiftech Micro-Res

[ALiEN2953]

Yes
Yes or Mp-1
Yes
PA120.2 rad
two Yate Loon fans in a pull configuration
7/16" Tygon or MasterKlear tubing 15-20ft
Swiftech Micro-Res


why the 7/16 inch i saw alot of people using this on XS but couldnt figure out y acan someone point me to a link about it.

oh and the fans arent changing.. so no point in telling me to

[learning curve]

the fans arent changing.. so no point in telling me toWith those fans are you going to use a fan controler? With those 2 fans you can run any rad you want. Too loud for me, but it is your ears that will bleed not mine.

[meionm]

why the 7/16 inch i saw alot of people using this on XS but couldnt figure out y acan someone point me to a link about it.


The 7/16 is earier to route around case and makes pretty good turns. One major drawback to it is pain in behind to put it on and take it off.

[Descada]

If you get a PA rad there is no point to using those fans. Look around there isnt anything mroe recommended than the yates, they are quiter and will do you just as good b/c PA doesnt need fans with that type of CFM.

As for your tubing question, this is in first post of XS forums from creidiki.

In any case, thanks to the lip effect of 10mm ID or less "1/2" barbs on 12mm ID (1/2ID) tubing, 7/16 is as or less restrictive than 1/2 in our tipical (short) loops, the loop bleeds better because linear flow speed (in feet per second) is higher, it has a tighter bend radius before kinking, and it puts less strain on blocks because its much lighter per unit lenght.