Auquamark drivers?

[*jj]

Hey all, been awhile since I posted but I was running some benchies today, and with a single card I am getting over 114,000 in Auquamark, but when I install the second video card in SLI it drops to just over 80,000. I don't get it..I mean all other benchmarks are doing fine (sig), so I know the SLI is configured correctly, I have changed the bios to allow the SLI, it says enabled in nVidia control panel, I see the green bar showing load balance, and again all other benchmarks are great for what I have. So I was wondering could the problem be a driver issue? I'm just not sure what the heck is going on, I'm using the newer 91.47's but I just don't get it :bang head

[*jj]

*bump*

are you serious? 3 days no replies. I guess people don't care about Aquamark anymore since it is not suported eh?

[Precision]

I honestly Don't know so I'll at least tell you that. I get about 113,XXX with one 7950GX2. I did have SLI 7900GT's But .. they just didn't do what I expected so I sent them back. Auqamark is old and runs really quick. So me personally. I wouldn't trust that one too much unless you're on a lower end system which i see you are not. If the others are showing good then you're good :) Me personaly I like 05 seems to give the most consistent results without change. I can run 06 and have BIG variations with NO changes made

[El<(')>Maxi]

Sorry I don't know anything about running SLI. There has to be some info out there, I doub't your the first guy to come across this problem.

[einstein2]

with my SLI system i get around 72K, just now tested and that is a much better boost than before :D