Just Some Dude Registered Joined Jun 6, 2006 Location Milwaukee, WI Nov 30, 2006 #1 I was bored and designed a wrap around shroud for an 86 Chevette heater core. Was wondering what you guys thought... Last edited: Nov 30, 2006
I was bored and designed a wrap around shroud for an 86 Chevette heater core. Was wondering what you guys thought...
4od Member Joined Jan 20, 2006 Location Westchester, NY Nov 30, 2006 #2 looks nice, but does it fit? You don't get congratulations until i get a pic of it on
Sleepy_Steve Member Joined Dec 3, 2004 Location VT... or MD Nov 30, 2006 #3 Looks like its in the WC section now Is that soldered in place? And what type of sheet metal is that??
Looks like its in the WC section now Is that soldered in place? And what type of sheet metal is that??
OP Just Some Dude Registered Joined Jun 6, 2006 Location Milwaukee, WI Nov 30, 2006 Thread Starter #4 LoL I hear ya. It does fit and I'll update when its done Its 22 gauge and I soldered the tabs together. On the bottom, the two flaps close over it and overlap. I'll solder it closed.
LoL I hear ya. It does fit and I'll update when its done Its 22 gauge and I soldered the tabs together. On the bottom, the two flaps close over it and overlap. I'll solder it closed.