This is a new build, I had a hard time off the bat getting the BIOS to recognize any drives (this was on the BIOS rev. that my board shipped with). However, once I removed the connection to all SATA adaptors except for the red Intel one, I was finally able to install windows.
Then when I would plug in my second hard drive into any of the black Intel SATA adaptors the BIOS stopped recognizing all hard drives again, and I could not boot windows.
So I updated to the latest BIOS from ASUS, rev. 1602. Now I can plug in hard drives and still have the red SATA adaptor be recognized, but none of the other ones work. The drive powers up fine (I can hear it) but is not recognized. I'm using WD2500KS drives.
Anytime I plug a hard drive into either of the black intel sata ports, the hard drive is not recognized by the bios or windows. I have tried plugging the hard drive into the EZ-RAID sata connectors as well, and it is still not detected by the bios or windows. I have tried multiple sata cables, sata power supplies, and WD2500KS hard drives. But none of these combinations provided any fix. I am on 1602 bios build. I have tried both AHCI and Standard IDE modes. Any help would be appreciated, thanks.
Then when I would plug in my second hard drive into any of the black Intel SATA adaptors the BIOS stopped recognizing all hard drives again, and I could not boot windows.
So I updated to the latest BIOS from ASUS, rev. 1602. Now I can plug in hard drives and still have the red SATA adaptor be recognized, but none of the other ones work. The drive powers up fine (I can hear it) but is not recognized. I'm using WD2500KS drives.
Anytime I plug a hard drive into either of the black intel sata ports, the hard drive is not recognized by the bios or windows. I have tried plugging the hard drive into the EZ-RAID sata connectors as well, and it is still not detected by the bios or windows. I have tried multiple sata cables, sata power supplies, and WD2500KS hard drives. But none of these combinations provided any fix. I am on 1602 bios build. I have tried both AHCI and Standard IDE modes. Any help would be appreciated, thanks.