- Joined
- Dec 20, 2004
- Location
- Hell's Kitchen, NYC
I just swapped out my NV-68 for a MCW60-B. The NV-68 will be going in the classifieds, but I wanted to clean it first. A combination of vinegar and water did a pretty good job on the copper, but it didn't remove the white "spots" on the inside of the acrylic. Suggestions? So far I haven't broken the original Danger Den seals on the block, and push-comes-to-shove I think I'd rather leave that to my eventual buyer, is there any way to clean out the white stuff without breaking the seals?
Here's a pic to show you what I mean:
Here's a pic to show you what I mean: