What size hose clamps should I get for 1/2 ID X 3/4 OD tubing? I was looking at the McMaster type 430 non-perforated worm clamps. They have 1/2 x 3/4 and 5/8 x 1-1/16 which are closest to the tubing size. Will the 1/2 x 3/4 fit over the 3/4OD tubing once it's on the barb? Should I go for the next larger size?
I was looking at either the Yate Loons(1350rpm, 47cfm) or the Mechatronics(1500rpm, 55cfm) for a mcr320. I hear everyone talking about the Yate Loons for a rad. Has anyone used the Mechatronics? They're listed has having a higher cfm at a lower dba than the Yate's but are they any good on a rad? Most of the high cfm, low dba fans are only good as case fans.
Thanks.
I was looking at either the Yate Loons(1350rpm, 47cfm) or the Mechatronics(1500rpm, 55cfm) for a mcr320. I hear everyone talking about the Yate Loons for a rad. Has anyone used the Mechatronics? They're listed has having a higher cfm at a lower dba than the Yate's but are they any good on a rad? Most of the high cfm, low dba fans are only good as case fans.
Thanks.