What are the benefits?

OCnewbee · Jan 25, 2007

If you run loop#1 opposed to loop#2?

Loop#1
MCP655->Swiftecg Storm->GPU Block->Themrcholl PA120.2->Swiftech Microres->MCP655

Loop#2
MCP655->Swiftecg Storm->Themrcholl PA120.2->GPU Block->Swiftech Microres->MCP655

Will it make a difference in temps on the cpu and gpu or very minimal?

nikhsub1 · Jan 25, 2007

Perceptually no difference whatsoever. Keep tubing runs to a minimum is far more important than loop order.

Graystar · Jan 25, 2007

Ditto.

Tekko · Jan 26, 2007

nothing to add WC god nikhsub1 has spoken...

OCnewbee · Jan 26, 2007

Tekko said:
nothing to add WC god nikhsub1 has spoken...

Okay, thanks guys i was just wondering thats all cause i have seen many different ways to setup loops i was curious.

artinhawaii · Jan 26, 2007

In general it is comparable to an electric DC circuit. No matter where the resistors are located, the resulting current is always the same.

There are still occasions where you might encounter trouble e.g. running the pump-out into the t-fill-line next if you don't use a reservoir. I believe that may cause some cavitation and air troubles under worst circumstances.

[O-CuK]Marci · Jan 26, 2007

i was just wondering thats all cause i have seen many different ways to setup loops i was curious

Have a read... http://www.overclockers.com/articles1088/

What are the benefits?

OCnewbee

Member

nikhsub1

Unoriginal Macho Moderator

Graystar

Member

Tekko

Member

OCnewbee

Member

artinhawaii

Registered

[O-CuK]Marci

Vendor - Thermochill

Similar threads