PDA

View Full Version : really Bad timings

nvidiaOCmaster
02-01-07, 10:17 AM
When I do them manually, i have the cycle time at... 10. Right now they are on auto and I OC'ed the ram to 280mhz per stick at 2.1V(max :().


Is this right or an incorrect reading? Will it effect my performance? Should I lower it? If I do I'm afraid i will lose my speed.

( s shot uploading)
meionm
02-01-07, 10:23 AM
The only improtant timings are the two in the middle 3-3-3-10. The two in the middle have highest impact on pc performance. You can set your timmings manually. If it is auto mode then you get 10 but manually you can change it.















]
nvidiaOCmaster
02-01-07, 10:25 AM
the cycle time is at like 31, that just kinda worried me.

http://img402.imageshack.us/img402/5489/wtfez4.jpg
meionm
02-01-07, 10:37 AM
Lower it,
nvidiaOCmaster
02-01-07, 11:01 AM
How much??? @ this frequency and 10, it doesn't post. Ill try somthing like 15-20
nvidiaOCmaster
02-01-07, 02:29 PM
5-5-5-10-20

Does this look good? Ill keep trying for lower.
Mycobacteria
02-01-07, 07:11 PM
What is the memory rated to do in the SPD? usually its more like 5..5.5.12 or 5.5.5.15 etc. If it can't go at the recomended times just RMA it.
meionm
02-01-07, 07:16 PM
What is the memory rated to do in the SPD? usually its more like 5..5.5.12 or 5.5.5.15 etc. If it can't go at the recomended times just RMA it.
It is pc3200 (400mhz), his memory is already doing 280 (560mhz)
nvidiaOCmaster
02-02-07, 01:58 PM
It is pc3200 (400mhz), his memory is already doing 280 (560mhz)

Flawlessly, I might add ;)

Got it up to 620 today :)
(Clanger)(DOA)
02-02-07, 03:17 PM
so 2.1v is as high as you could go>?
nvidiaOCmaster
02-02-07, 03:59 PM
so 2.1v is as high as you could go>?

Yep. board dosent allow any more than that. If I could go higher, I could take the freq. even higher.
nvidiaOCmaster
02-03-07, 09:19 AM
720mhz....

Im going to keep it @ 600 just to be safe, I cant be blowing up mem chips when im this broke.

Would it be safe to run it @ 720 daily?