Last few questions before I put my w/c in

[pak]

Well heres what I got.

Coolrad 32t 120x3 radiator
White water block
MCP 655
Tline set up

I plan to put my rad on top of my case with the fans blowing down into the case.

Now I know this question has been asked 1,000 times, but the WW block has 3 fittings on it. Do I make it work with 2 in and 1 out or 1 in and 2 out?

Also as far as the mcp655 goes. Can I mount it anyway? Upside down, side ways, or how ever I need to?

anything else you guys wanna warn me out?

--pak

[CGR]

It would be better for the rad fans to be blowing out the top so it acts as a blowhole.

Center one in and sides out on the WW block.

Not sure if pumps should be put upside down. I sure wouldnt put one like that, righside up or on its side are should be ok though.

[||Console||]

Pump is fine upside down as long as when you are filling your system you turn your case so you can prime the pump do not ! run it without water in it it kills pumps very fast .

[pak]

If i push the air up, wont that put hot air in the rad?

--pak

[||Console||]

what i mean is every thing you power on the pump make sure that ther eis water @ the inlet of the pump

[pak]

Sorry, I meant in reply to CGR and the fan orientation.

--pak

[||Console||]

I think what he was trying to say is hot air rises so dont fight it by blowing the hot air back into your case in a dowwared direction have the fans Pulling from the top of the rad away from your case .