Which Peltier.....Air cooled

[KILLorBE]

Should I get a 62 or a 80 Watt peltier for my PIII600@888 2.0 CV?.
I'm gonna use it with my PEP66.

Any suggestions?

TIA

[hunter00]

i would answer but your picture scares me:(

[Warlord2]

I say a 80watt would be best but you need some good cooling for it

[ButcherUK]

Assuming you have a delta on that pep66 you should get roughly these temps...
No TEC = 33C
62W TEC = 23C
80W TEC = 19C
This assumes 25C ambient and 16V TEC run at 12V.

[KILLorBE]

ThanX all, think I'll try the 80W Peltier as its only $4 more.
Originally posted by ButcherUK
Assuming you have a delta on that pep66 you should get roughly these temps...
No TEC = 33C
62W TEC = 23C
80W TEC = 19C
This assumes 25C ambient and 16V TEC run at 12V.

Could you tell me how to calculate that? (I'm sure I've read it somewhere but it wasn't really necessary for me to remember back then).
I forgot to mention that I already have a 62W TEC on my PEP66 (it isn't mine, that's probably the reason I forgot :p )
The temps are:
24C ambient
24-25C full load (average 24C after 3 days F@H, surfing, playing MP3's and the other usual stuff).
Sorry no Idle temps all I know its below 14C (haven't done anything to prevent condensation...yet :eh?: )
And yes I have a Delta,and yes the TEC runs @12V, I must say that I didn't lap the coldplate really well and I used generic paste cuz I'll have to put my own TEC on in a week or two, I'll do a better job then:D , so you were VERY close, Excellent ButcherUK.

I hope I'll hit 900 (hey its a cA2) with the 80W TEC, I was stuck at 840 before I used the 62W TEC (Well on a blue monday I got it stable at 852 but the next day it was a nogo).
I'll also make two fan adapters, One for a 92mm Sunon fan ~42CFM but less MAP as the Delta and one for a 80mm 46CFM Delta.......No more screaming gremlins in my box.

BTW: hunter00 do you want me to remove the picture?:p

[hunter00]

naw i actually love that movie, im a huge kubrick fan

[ButcherUK]

Originally posted by KILLorBE
Could you tell me how to calculate that? (I'm sure I've read it somewhere but it wasn't really necessary for me to remember back then).
I use a program to calc it it takes into account cold plate, TEC, hsf, and ambient measurements. I was kind of guessing so of the params such as coldplate and assuming 16V TECs at 12V so it;s not a bad guess. :)
TEC calc can be found here: http://come.to/MrEvil

[Silver]

I LOVE that picture. I can really relate to the guy that uses it. Is that not a dedicated overclocker or what.