agp/fsb and pci/fsb buses

[eeengineer82]

i have a gigabyte ga-6oxc mainboard and a celeron 633.i can't adjust agp/fsb and pci/fsb multipliers, mainboard does it itself.
i adjust cpu as 9.5*100 and the computer opened but windows didn't.is there anything to do with this problem?
since windows doesn't open i can't see fsb and pci buses' speed,66-33 or 100-50?
also i thought first i must overclock then setup windows so that windows can open.is it true?
thanks for your advices.

[The Doors]

Hi eeengineer82, welcome to the Forum,
First of all check your Cellie temp @full load, I suggest MotherBoardMonitor that you can found here (http://mbm.livewiredev.com/), never must go above 40-45 degree C, but less is better. If the temp is right, well, try to increase the VCore (Cpu voltage) but not over the 10-15% of the rated voltage.

[eeengineer82]

voltage is 1.85.
temp is 32-33 degrees but in bios

[The Doors]

Well, they are right,
infact 1.85v or 1.9v is the right voltage for this kind of Cellie's OCed, and about the temp reported by the Bios, generally is just @full load, even if into win can be 2-3 degree up. My suggestion at this point is to set an higher voltage for the mem modules if possible, @3.4 or 3.5v :)

[The Doors]

Excuse me, but looking the Mobo user manual, I found that you can set a desidered Fsb, properly setting the dip switchs on the Mobo, and not the Agp/Pci bus like on all the other i815 Mobo's.