- Joined
- Aug 29, 2006
I just finished putting in this kit
http://www.crazypc.com/products/9370.html
as recommended by members of this forum
I love it so far, my fish tank is louder than my PC.
I just wanna make sure some stuff
1) E6700 @ 3.4GHZ temps of Core0-39C, Core1-40C on load, Speedfan 4.32 (i figure Core is better measure than Temp1, which reads 35C). I think these are good numbers right? On a Zalman 9700 Air, I was getting 58ish on load.
2) Do I need to bleed the reservoir to the rim even though everything's working fine?
3) I read that I can control the fan speed, which software do I use for that?
4) UV dye , bad for motor? I added a touch of alcohol, as recommended for extra coolant/viscosity control, bad for motor?
5) I used the shortest route possible, as recommended. However, some of the tubes have very high torque pressure, but just screwed into place. It's not kinking as of now, would it kink sometime down the road? Is there anything I should worry about like cracking or anything?
Thanks in advance, I have enjoyed all the nice things and helpful comments that have made me dive right into water cooling and now that I'm in, I don't wanna go back to air!
http://www.crazypc.com/products/9370.html
as recommended by members of this forum
I love it so far, my fish tank is louder than my PC.
I just wanna make sure some stuff
1) E6700 @ 3.4GHZ temps of Core0-39C, Core1-40C on load, Speedfan 4.32 (i figure Core is better measure than Temp1, which reads 35C). I think these are good numbers right? On a Zalman 9700 Air, I was getting 58ish on load.
2) Do I need to bleed the reservoir to the rim even though everything's working fine?
3) I read that I can control the fan speed, which software do I use for that?
4) UV dye , bad for motor? I added a touch of alcohol, as recommended for extra coolant/viscosity control, bad for motor?
5) I used the shortest route possible, as recommended. However, some of the tubes have very high torque pressure, but just screwed into place. It's not kinking as of now, would it kink sometime down the road? Is there anything I should worry about like cracking or anything?
Thanks in advance, I have enjoyed all the nice things and helpful comments that have made me dive right into water cooling and now that I'm in, I don't wanna go back to air!