Micron -5B F @ DDR400 value module question

malvindo · May 11, 2007

as above
buy value ram got micron -5B F
memtest @ 2.5-3-2-6 @fsb 200 @ 2.6v stable (few pass)

memtest @2.5.3-3-7 @fsb 220 @ 2.6v cannot BOOT

memtest @2.5.3-3-7 @fsb 220 @ 2.7v stable (few pass)

any1 used this chip? how far this chip fun @ fsb? & how tight? @ what voltage?

and if compared with Hynix CTP-D43
i can run @ 2.5-3-3-6 @fsb 230 @ 2.7v stable

can micron outperform Hynix CT-D43?

thx in advance

Eldonko · May 11, 2007

Micron -5B F are good chips, but cas 2.5 isnt going to get you far. Use 3-3-3 for best result.

malvindo · May 11, 2007

Eldonko said:
Micron -5B F are good chips, but cas 2.5 isnt going to get you far. Use 3-3-3 for best result.

ooo
ok will try 3-3-3 , how far is the target & what is their optimal voltage?

Eldonko · May 12, 2007

Well its a value kit so it may be a bit lower than another, but you should see at least 250-260 @ 3-3-3 and 2.8ish volts. I would try and stay at 2.80v-2.85v for 24/7 op .

malvindo · May 12, 2007

Eldonko said:
Well its a value kit so it may be a bit lower than another, but you should see at least 250-260 @ 3-3-3 and 2.8ish volts. I would try and stay at 2.80v-2.85v for 24/7 op .

wooow, seem Micron -5B F better than Hynix CT-D43
seems need to pump more on voltage

malvindo · May 13, 2007

got 260 @3-3-3-8 @2.8v
will try 3-4-4-8 to check the highest FSB

thx Eldonko

Eldonko · May 13, 2007

Cool, GJ

malvindo · May 13, 2007

Eldonko said:
Cool, GJ

highest fsb stable is 262

3-3-3-8-1T @2.8v my mobo don't have 2.85 option

can't find stable in 265

try loosen timing n rise the voltage still the same

seems stuck @ 260

will try my CT-D43 can achieve

Micron -5B F @ DDR400 value module question

malvindo

Member

Eldonko

Revolutionary Mule

malvindo

Member

Eldonko

Revolutionary Mule

malvindo

Member

malvindo

Member

Eldonko

Revolutionary Mule

malvindo

Member

Similar threads