- Joined
- Nov 22, 2006
- Location
- Just outside Wright-Patterson AFB
Last time I redid my HTPC, I had ordered an extra foot of Tygon, as I knew I'd need more tubing. Well, I guess I didn't read close enough, as it had a much thinner wall than the rest of my tubing. I installed it anyway, as it didn't have any tight bends or other stresses.
Well now, a couple of months later, I went in two swap a hard drive, and found the thinwall Tygon had virtually collapsed! I think the power of the MCP350 is the only thing that saved my rig. Is there any way to hold the tubing in a non collapsed shape? Hose clamp, zip tie, etc?
Well now, a couple of months later, I went in two swap a hard drive, and found the thinwall Tygon had virtually collapsed! I think the power of the MCP350 is the only thing that saved my rig. Is there any way to hold the tubing in a non collapsed shape? Hose clamp, zip tie, etc?