MCP655 enough for this loop?

[eightballrj]

MCW60/Storm/PA120.3/PA120.2? I am thinking of reworking my loop and I really don't know if I want to go to two loops or two pumps for that matter I guess.

Would that be adequate?

[CCUABIDExORxDIE]

yea 1 mcp655 should be more then enough for that, i think your temps will be fine, worst thing you can do is test it.

[jivetrky]

I would say that the 120.2 would be kinda unneeded. That 120.3 should handle a CPU/GPu setup just fine by itself. Just kinda creating more resistance in the loop IMO.

[eightballrj]

Yeh I know it will but I am trying to get a water loop(Rads and Blocks at least) that I shouldn't have to upgrade again. Also, I am looking at a few different cases (MM Duality/Horizon, TJ07) and those rads will go in them. My P180 would be hopeless to fit them unless I had some huge external contraption, haha.

[QuietIce]

One MCP655 will easily take care of that loop. One MCP655 on P4 can handle the loop shown below ... :)

[OCnewbee]

My MCP655 runs through a Storm, EK-FC8800, PA120.2, Microres. Very good temps and flow.