80mm on SK6 not doing too bad

[demon-eater]

I recently asked how to mount a 80mm fan on a SK6 and since i was getting 92mm's to replace my 80mm's. Now that my 92mm's came i put a 80mm on my HS and its at 40C full load, (about 20 minutes prime 95) not bad because my ys-tech used to do the same. Im happy with that because its alot quiter now (my pc that is). i have one 92mm in the bottom front blowing in and the other one inbetween my power supply and burner up top sucking out.. and it seems to work just fine for me..

[Yodums]

Hmm are you using an adapter or how? The SK6 only takes 60mm fan doesn't it.

[demon-eater]

yes you are right but you can mount a 80mm fan on sideways so the the corners are sticking out in the middle of each side of the heatsink.

[The Overclocker]

are the cfm of the old fan and new fan the same?

[demon-eater]

basically the 80mm is 43cfm and the 60mm was 40cfm