yeah i ordered the parts already. I spent money like it was no object during the process...
I'll keep what i'm getting, but your advice is good and should be heeded by anyone reading this thread and thinking about parts.
I like the case im getting because it has a gap above the mobo tray fit for a rad, the psu is at the bottom and the motherboard is upright. Most cases like that have an inverted mobo, and with the heatpiped mobos this isn't so good. It will have tons of airflow too which will be good.
@STDU, that is very similar to the setup i was thinking off. Although i have a 3x120mm rad which i will mount in the top with some carefull cutting. (we shall see when the case gets here anyway)
The build will be this comming weekend if everything arrives by then (which it should). I will update here with pics! Its my first water build. I'm not into "riceing" my cases. The fact that the TJ09 has a window is actually a minus as far as i'm concerned. Therefore it wont be asthetics, just performance that i am after.
Thanks all, i'll keep you updated.
p.s i went with the copper top because i figured that the price was ok if one considered that the anodised top would infact "break" and destory the block through electrolysis at some point in the furture. In which case it was cheaper than a new block. Of course this scenario is 90% unlikeally and water blocks will improve by that stage too. Either way, i justified it when i handed over the money. I won't return it though, i may as well use it. (plus it looks bling.... (damn it, thats case riceing!*slaps own wrist*))