• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

D-tek Fuzion Accelerator Nozzles

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

meionm

Member
Joined
Mar 8, 2004
I didn't see any threads about it or I just missed them. Anyways there are these nozzles for dtek fuzion. Does anyone have any experience with them? There are like five of them and which one would you use? I was thinking that 3.5mm would give best result but it is only a guess.


Here's link to dtek webiste for them, also petra and sidewindercomputers have them.
http://www.dtekcustoms.com/index.asp?PageAction=VIEWPROD&ProdID=203
 
I didn't see any threads about it or I just missed them. Anyways there are these nozzles for dtek fuzion. Does anyone have any experience with them? There are like five of them and which one would you use? I was thinking that 3.5mm would give best result but it is only a guess.


Here's link to dtek webiste for them, also petra and sidewindercomputers have them.
http://www.dtekcustoms.com/index.asp?PageAction=VIEWPROD&ProdID=203

There is a long thread on this at *cough, cough* http://www.xtremesystems.org/forums/showthread.php?t=161386 *cough, cough*.

Yes, the 3.5 should give the best result, but of course be the most restrictive.
 
I just put my quad nozzle in the other night and so far it has dropped my load temps by about 3c.

--pak
 
Back