Permanent or Reversable fillers

[Sonny]

Permanent - Tamiya 2 Part Putty. 2 sticks of clay like substance mix/twist together then rub into the pits/slits of your XPs. Wait a few minutes to harden then bridge L1 dots with conductive ink penn. Clean & easy:beer:

Reversable - Chemask (http://www.chemtronics.com/catalog/catalog.cgi?action=list_products&category=9). Squirt it on wait a few minutes then bridge L1 dots. Simple & fast. Great for soldering/volt mod jobs too:beer:

[The Coolest]

Nice, kewl... I said it already, but I'll say it again: "Now, if I only had the XP..."

[Sonny]

Originally posted by The Coolest
Nice, kewl... I said it already, but I'll say it again: "Now, if I only had the XP..." Tamiya putty when it dries is ready for painting too so no problems with the silver ink/paint not sticking to it;)

[wildbilly2k]

if i run this putty into the holes wont it get on the bridges and keep them from conducting and where can i get a conductive ink pen and where can i get this putty if it really works

[Sonny]

You smudge the "putty" into the slits/pits with you thumb then clean the top off to make sure you have nothing on the L1 dots. Just do a search for Chemtronics Circuitworks Conductive Ink Pen CW2200MTP & go to a modeling shop for the putty.