Help with Unlocking AthlonXP!!!

[NHLSPeX]

I'm having problem trying to unlock my Athlon XP 1600+. I superglued the gaps and used conductive silver epoxy(from CrazyPC) to connect the bridges in L1. When I booted up, the CPU either shows up as a Athlon 1200MHz or AthlonXP 1444MHz(if i remember correctly). I got this on my first try so I did it again from scratch. I got the same thing. Could you help me out? Do you think is the silver epoxy(not being too conductive) or what am I doing wrong? Any tips! Thanks!

Current Setup:
Abit KR7A
AthlonXP 1600+@1.53GHz (10.5 x 145) 1.75v
Alpha PAL8045 w/Delta 68cfm
VisionTek Geforce3 Ti-200
Crucial 256 MB PC2100 DDR
20GB WD HD
Antec SX1040B 400w PS
Win2k Pro

[Placid]

For me I have used both super glue and white out.
White out was easier to use for me because you can see it vs. superglue is clear.

I have also used a needle and a toothpick to apply the unlocking materiel, for me the toothpick worked much better as the wood seems to be somewhat absorbent and the material doesn't blob as easily.

Try using a very small amount of material on a toothpick and push it into the bridge dots and let it dry 10 mins then go back with a very small amount and connect the dot's.

Let the stuff dry well before putting it back in the pc.

Goodluck.

[TitaniumFryCook]

This is how you unlock your XP properly. No glue, defoggers or pens needed.

It seems every 10th post is "How do I unlock my XP?" There is ONLY 1 way to do it easily and so that it is totally reversible. Don't hack up your CPU with glue and defogger kits, how damn barbaric! See the link below,

http://www.vr-zone.com/guides/AMD/AthlonXPUnlock/



big ups to nikhsub1 for posting this....a really simple/effective solution. Even n00bs (/me points to left) can do it!

later,
TitaniumFryCook