New IP35Pro and Q6600 Build ...QUESTIONS

Setup is in my sig:

1st off i have my q6600 overclocked slightly to 3ghz(333x9)
My temps run about 24-28 C between the 4 cores at idle, it is throttled down.
My ram is crucial ballistix 8500, i have it set at a 1:1 ratio and tried to set it to 1T timing in bios( manual settings and saved ), but cpuz reports it as 2T and at 5-5-5-18 timings. I am using beta bios ver 3.

Is there anything I should make adjustments to , to maximize my performance with my current setup such as ram or bios settings? I am only wanting to clock the 6600 to the current 3ghz max.

Fill out this BIOS template w/ your current settings, and post it in this thread...

ABIT IP35-Pro
OC GURU:

CPU OPERATING SPEED................ - USER DEFINE
EXTERNAL CLOCK..................... - 333MHz
MULTIPLIER FACTOR.................. - 9
# ESTIMATED NEW CPU CLOCK.......... - 2997MHz
DRAM SPEED (CPURAM) 1:1.20....... - 1:1.5 DDR2-
PCI EXPRESS CLOCK.................. - 100MHz

VOLTAGE CONTROL:

CPU CORE VOLTAGE................... - 1.3V
DDR2 VOLTAGE....................... - 2.2V
CPU VTT 1.2V VOLTAGE............... - 1.2V
MCH 1.25V VOLTAGE.................. - 1.25V
ICH 1.05V VOLTAGE.................. - 1.05V
ICHIO 1.5V VOLTAGE................. - 1.5V
DDR2 REFERENCE VOLTAGE............. - 0%
CPU GTLREF 0+2..................... - 67%
CPU GTLREF 1+4..................... - 67%

ADVANCED CHIPSET FEATURES:

DRAM TIMING SELECTABLE............. - by spd
CAS LATENCY TIME (TCL)............. - 5
RAS# TO CAS# DELAY (TRCD).......... - 5
RAS# PRECHARGE (TRP)............... - 5
PRECHARGE DELAY (TRAS)............. - 18
REFRESH CYCLE TIME (TRFC).......... - 42
WRITE RECOVERY TIME (TWR).......... - ?
WRITE TO READ DELAY (TWTR)......... - 11
ACT TO ACT TIME (TRRD)............. - 3
READ TO PRECHARGE (TRTP)........... - 3
COMMAND RATE....................... - 2T
PEG FORCE X1....................... - DISABLED
INIT DISPLAY FIRST................. - PCIEX

ADVANCED BIOS FEATURES / CPU FEATURES:

THERMAL CONTROL.................... - DISABLED
LIMIT CPUID MAXVAL................. - DISABLED
C1E FUNCTION....................... - DISABLED
EXECUTE DISABLE BIT................ - ENABLED
VIRTUALISATION TECHNOLOGY.......... - ENABLED
EIST FUNCTION...................... - DISABLED

up

cpu-v = 1.45
CPUVTT = 1.27
MCH = 1.33
CPUGTL 68% for both.

change
Dram speed to 1:1
PCIE = 101

manually set you timings to what it shows at auto, leave CMD-rate at 2T.

now start upping you fsb higher...