- Joined
- Jan 26, 2001
Right now I have an unlidded Q6600 B3 stepping under water using the following items:
Apogee GT
MCP655
3x120mm single pass radiator (DangerDen)
dual 3 1/2" rez (have a micro rez but haven't installed it yet)
I have applied 1.4875 volts via the BIOS but every program I have (everest, speedfan, ASUS AI, CPUID) reads the voltage at 1.35 to the chip. I don't know if ASUS is wrong or these programs are wrong...don't have a multimeter on me.
I am currently at 3.33Ghz as you can see from CPUID and Everest in the picture below. I think my temps are a little high for this setup and cannot for the life of me figure out why.
Apogee GT
MCP655
3x120mm single pass radiator (DangerDen)
dual 3 1/2" rez (have a micro rez but haven't installed it yet)
I have applied 1.4875 volts via the BIOS but every program I have (everest, speedfan, ASUS AI, CPUID) reads the voltage at 1.35 to the chip. I don't know if ASUS is wrong or these programs are wrong...don't have a multimeter on me.
I am currently at 3.33Ghz as you can see from CPUID and Everest in the picture below. I think my temps are a little high for this setup and cannot for the life of me figure out why.