adding a chipset cooler to my loop- where should it go?

My chipset cooler died so I picked up an EK-Nf4 block with 1/2 barbs. Where is the best place to put it before or after the cpu block? My set up is: Ehiem 1250 pump, DangerDen TDX cpu block, DangerDen Black ice extreme with 2 shrouded 120mm fans in a push/pull.

I'm leaning toward after the CPU cooler but wanted to here some thoughts/opinions on placement.

Thanks,
PWA

makes no difference. Just stick with the way that uses the least amount of tubing.

Yep...makes no difference since the water temps will all be the same eventually anyhow.