Remove MCW50 1/2" Nozzles

[Jim Morbid]

Hi all

As the Subject says I'm trying to remove the 1/2 nozzles on the MCW50 but have no idea how to go about it?

Here is the picture: http://www.swiftnets.com/assets/images/products/MCW50/mcw50-w1-2barb.jpg

Then, on a related issue, how do I put them back in once I figure out how to take them off :p ?

Thanks,

JM

[Froggy]

Push the nozzles in & hold that grey ring closest to the block, & pull the nozzles out. For re-install, simply push the nozzle back in & give it a tug back to seat it.

[Jim Morbid]

Like a charm! Thanks

[Jim Morbid]

Okay another question: I need to remove the "grey ring closest to the block" now. Is there a way that doesn't require openning the whole block and, with that said, is it possible at all?!

Thanks,

JM

[Froggy]

That I have no clue on. I would suggest you contact Swiftech directly for that info.