I just chipped my NF4 because of mounting issues. I've mounted this a couple of times before but I always had a bad feeling of chipping the corners of the chip or the block touching the little parts on the chip - and it has finally happened.
It's such a pain to work with 1/2 tubing. I think it's this reason that my block couldn't be seated properly and caused my northbridge to chip.
Are there any methods you use so that something like this doesn't happen?
It's such a pain to work with 1/2 tubing. I think it's this reason that my block couldn't be seated properly and caused my northbridge to chip.
Are there any methods you use so that something like this doesn't happen?