do u think i will see better temps if i run a Apogee GTX over a GT on my q6600?

hank123 · Mar 22, 2008

do u think i will see better temps if i run a Apogee GTX over a GT on my q6600?
or is there a block out there that will do better then that?

illuxion · Mar 22, 2008

nozzled and bowed FuZion is your best bet from what I've read, and the fuzion has a much lower pressure drop.

Here's something I found searching yahoo http://www.xtremesystems.org/forums/showthread.php?t=131297

BobcatDan · Mar 23, 2008

The fuzion or GTX would be better, but not by enough to really justify it. I added the nozzle kit to my fuzion and dropped a few degrees.
Dan

Moto7451 · Mar 23, 2008

If it's not already bowed, buy the bowed block O ring and install it. Cheap performance boost

.

billb · Mar 23, 2008

hank123 said:
do u think i will see better temps if i run a Apogee GTX over a GT on my q6600?
or is there a block out there that will do better then that?

Martin's Flow rate Estimator can help answer that.

Here's the Discussion Thread

Big Mike · Mar 25, 2008

If you have a G0 chip a bowed GT should be sufficient, I've never seen over 64C on the hottest core fully loaded at 1.45v and 3.8ghz or so with a PA120.3 and an overclocked G80 GTS in the loop.

hung · Mar 25, 2008

Well what kinds of temps are you getting right now with your GT? I actually underestimated my GT at first, but I'm happy with 37C idle...45C load.

do u think i will see better temps if i run a Apogee GTX over a GT on my q6600?

hank123

Member

illuxion

Registered

BobcatDan

Member

Moto7451

Senior Something

billb

Member

Big Mike

Senior Head of Import Performance

hung

Member

Similar threads