GA-P35-DS4 with F12 BIOS - 1T/2T memory setting?

[veryhumid]

Is there a 1T/2T memory setting in the BIOS? I don't see it anywhere, even with the Ctrl-F1 trick...

[clocker2]

Not that I've found.

[mattspalace]

Here's a stupid question..

What's the default voltage for the memory???? I'm guessing 1.8v or 2.0v, but I can't find the number anywhere.

[Technophobe]

Here's a stupid question..

What's the default voltage for the memory???? I'm guessing 1.8v or 2.0v, but I can't find the number anywhere.

My DS3P shows 1.88v in PC Health and outher monitoring software. Check these out for your setup.

[mattspalace]

Ah, yeah it's in the bios.. Shesh, you think it would just say in the manual. I must be the only dude who actually reads them.

[clocker2]

Here's a stupid question..

What's the default voltage for the memory???? I'm guessing 1.8v or 2.0v, but I can't find the number anywhere.
Mine was 1.8v by default.

I hate the way Gigabyte doesn't tell you the actual voltage and just allows you to add/subtract from some mysterious default number.
The board has also seriously overvolted the vCore on both my 45nm chips when set to "Auto", so the first thing I did was progressively knock the voltage down (running stock clocks) to see where I needed to start.

Besides that-and the crappy placement of the SATA ports- it's a great board.

[mattspalace]

Luckily, enough of these E8400's have overclocked consistently enough that I knew about where to start. The memory dividers are stupid too.

Board runs like a champ though so I can't complain too much.