- Joined
- Jun 11, 2001
- Location
- Bris, QLD, AUS
I am using an abit st6 with a Celeron 600.
The highest vcore I can select is 1.625 and I have tried doing the reflash trick but it doesn't work.
I know the chip is capable of 1008mhz with 1.8v cause it had like this on my BH6
Right now its stable @[email protected], If only I could get a bit more voltage, it could reach its potental dammit, especially since i now have 1mhz bus speed increments, and temp sensor.
Is there a way to get it higher without that vid pin mod?(whatever it is).
otherwise how hard is the vid mod and can it work on an fcpga celeron, where could i find out about it?
thanks.
The highest vcore I can select is 1.625 and I have tried doing the reflash trick but it doesn't work.
I know the chip is capable of 1008mhz with 1.8v cause it had like this on my BH6
Right now its stable @[email protected], If only I could get a bit more voltage, it could reach its potental dammit, especially since i now have 1mhz bus speed increments, and temp sensor.
Is there a way to get it higher without that vid pin mod?(whatever it is).
otherwise how hard is the vid mod and can it work on an fcpga celeron, where could i find out about it?
thanks.