Did I fry it??!!?!?!?!?!

[sfa ok]

I was o/cing my Visiontek GF3 Ti200, and when I started 3dmark, everything got really dim, and stayed that way when I rebooted. I tried clocking it back down, but that didn't help. I turned off the computer, and now I'm getting nothing on the screen, but the monitor is getting a signal. Did I fry it? Or is there something else I can do? :(

[cjlax5]

how much did you overclock it?

[sfa ok]

I don't remember, exactly. I was playing around with settings in NVmax, and it refreshed itself while I was looking around at what people were getting theirs to. I then started 3dmark, but it wasn't anything insanely high, I'm almost positive it was lower than Wildone's successful o/c.

[mEKbOY]

I doubt you actualy fried it..Its almost impossible to do unless the heatsink fell off or anything like that. I bet your oc program that you were using may have caused some type of problem with the card.

[sfa ok]

I tried clearing the CMOS, and reseating the card, it's still not giving a picture. Any ideas other than RMA?

[RainMaQer]

Do you have another comp you can try the card in? Does nvmax do lowlevel oc'ing? If it does you might try flashing the bios on it.

[PipeBom]

First I would uninstall your o/cing program and then uninstall all of your card drivers. If that doesn't work then try installing another graphics card into your computer. Something similar happened to a friend of mine and that worked for him. Good Luck!!
:cool: