- Joined
- Apr 28, 2008
- Location
- Melb, AUS
hi all, P5E flashed to a Rampage Formula, performing good as, but one problem
my voltage (when set to 1.35000v in BIOS will jump around according to CPU-Z reading. it can jump to and fro between 1.344 and 1.336 in a matter of seconds.
this may be becuase of loadline calibration, which is enabled.
but when the voltage is set to 1.36250v in BIOS, i hvae no vdroop at all, cos it's the same voltage during idle and load state, no matter how long i run Prime95
so it's only when i revert to a lower voltage, i get the voltage jumping around.
is this a big problem, or is it one of those "meh" or "CBF" things?
also, any ideas or solutions to this?
thanks.
my voltage (when set to 1.35000v in BIOS will jump around according to CPU-Z reading. it can jump to and fro between 1.344 and 1.336 in a matter of seconds.
this may be becuase of loadline calibration, which is enabled.
but when the voltage is set to 1.36250v in BIOS, i hvae no vdroop at all, cos it's the same voltage during idle and load state, no matter how long i run Prime95
so it's only when i revert to a lower voltage, i get the voltage jumping around.
is this a big problem, or is it one of those "meh" or "CBF" things?
also, any ideas or solutions to this?
thanks.