Request: Comparison between CPU blocks (Ek supreme, GTZ, Dtek fusion V2 (mod+stock)

[Blazing fire]

Those 3 are the top performing ones. In addition, the dtek fusion v2 has quad insert, performance nozzle (http://www.dtekcustoms.com/browseproducts/D-Tek-FuZion-Accelerator-Nozzle-Kit.HTML) (3.5 to 6.5) which affects temperatures. Some say quad reduces performance, some say 4.5mm nozzle works best etc.

So, the variables are:

1) Dtek Stock
2) Dtek Quad + stock nozzle
3) Dtek Stock nozzle only
4) Dtek Quad only
5) Ek supreme
6) GTZ.

[Blazing fire]

Ah yet another myth. Does the pump produce enough heat to affect temperatures? To test this out, run

1) Block > Res > Pump > Rad
2) Block > Rad > Res > Pump

[updawg]

Their is a comparison between the Ek Supreme and the GTZ on xtremesytems forum. It came out as a tie, the difference was negligible. The supreme had a tad better flow then the GTZ too. If I can find the link i'll post it up here.

[Blazing fire]

Links would be great! I only saw dtek vs GTZ and that was a tie.

[Blazing fire]

Bump

[RedRaider]

XS is down at the moment, when it comes back up i'll post a link...

The test showed the GTZ beating the EK Supreme by .02*C, D-TEK was in third... This was tested with only a one pump system, another test with two pumps showed the EK Supreme kicking the D-TEK by 1.5-2 C...

The flowrate, best to worst:

D-TEK / GTZ / EK Supreme

A CPU only loop, IMO, EK SUPREME reigns SUPREME...

[Blazing fire]

Great! Glad I bought the ek supreme. Btw, one pump system = cpu only loop + mcp655?

[RedRaider]

Try CPU only loop with Dual MCP355's with XSPC tops..... (my setup)

[Blazing fire]

Try CPU only loop with Dual MCP355's with XSPC tops.....

huh? So was it single pump with 1 CPU block or what?

Bump for request.

[RedRaider]

Heres the links...

LINK 1 (http://www.xtremesystems.org/forums/showthread.php?t=198681&highlight=Supreme) -- EK Supreme / Apogee GTZ / D-TEK v2

LINK 2 (http://www.xtremesystems.org/forums/showthread.php?t=172891&highlight=Supreme&page=2) -- EK Supreme VS D-TEK v2 (dual pumps - MCP655's) - (start reading at post #39)

[Blazing fire]

Great! Bump for request again

[RedRaider]

What request are you bumping for ???

[Blazing fire]

1) Dtek Stock
2) Dtek Quad + stock nozzle
3) Dtek Stock nozzle only
4) Dtek Quad only

[Blazing fire]

Found a great link: http://www.xtremesystems.org/forums/showthread.php?t=168551

Though no temperature test...