Feser X-Changer 360mm Xtreme Performance Radiator

[orthomofo]

what's the deal with these? anybody have thoughts or experience with these?

could they be that better in low noise, low cfm heat dissipation, and quality of make?

but am i reading this properly, 1/4" barbs?

[Spawn-Inc]

what's the deal with these? anybody have thoughts or experience with these?

could they be that better in low noise, low cfm heat dissipation, and quality of make?

but am i reading this properly, 1/4" barbs?

not sure on qualtiy or anything like that, i too would like to know.

but as for the 1/4" barb your most likely reading the thread type and its G 1/4" which means up to 1/2" barb size.

[baditude_df]

They are very good rads, that work very well with lowspeed fans. That being said, that also come with a fairly high price tag. This will be my next rad as a matter of fact.

Check this out:
http://www.martinsliquidlab.com/The-Feser-Company-X-Changer-480-Review.html
From all accounts, same goes for the triple you are asking about.

[Conumdrum]

See this? I just got one for $99, dunno if he ran out yet.

http://www.ocforums.com/showthread.php?t=577382

[baditude_df]

Holy SH*T! lol. Thx bud.

[Kenquinn]

what's the deal with these? anybody have thoughts or experience with these?

could they be that better in low noise, low cfm heat dissipation, and quality of make?

but am i reading this properly, 1/4" barbs?

They have 1/4 inch Barb Threading not 1/4 inch barbs.

The threading is what the barbs screw in to its Independent of the barb size. You just have to make sure you barbs have 1/4 inch threading which most do.

[orthomofo]

thanks dude. i checked my post with my phone during lunch and saw the deal w/ DD. i called them up and they only had 3 left. i picked mine up and then some. they sold out while i was on the phone with them. THANKS DUDE

[Conumdrum]

No worries, glad to help. I got one for future use. And got rid of DD's extra stock, he's good peeps and glad to help everyone out.