Can anyone tell me how to solder a 240v fan or water pump to my 300w psu so that the water pump will turn on automatically when my system is turned on?
I managed to squeeze a relay inside the PSU that powered itself up when the +12V came on. This relay was connected to the AC power jack and I brought the Hot and Neutral out through one of the slits in the PSU to a terminal block with a plastic protective cover over it. I then cut the AC plug off of my pump and put it on the terminal block. If you lok closely, you can see the green safety ground wire from the pump is lugged to the chassis.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.