one quick q

[Mike K]

I downloaded motherboard monitor to use something else besides bios and Sandra and its displays my core voltage at +1.64 and it says its in the red zone. in the bios its at default so I am not too worried about it because my cpus not overclocked. I think theres something wrong with the software because sometimes it gives me a warning that my cpu fan slowed down to 0rpm!LOL!:eek: :D

[Maximus Nickus]

Check it hasn't!!!! Don't want ne burnt CPU's!!!

[Mike K]

I know it hasn' t, I have the side panel off a lot so I can see it. I am more cautious now ever since I burnt 2 1GHZ T-birds:(
Does ne1 know if +1.64V is the default for the cpu?

[Henry Rollins II]

Some cpu HSF does not give the correct rpm signal. I had that problem with Zalman hsf a while ago, sometimes it showed 0 rpm, sometimes 15.000 rpm.

regards,
Henry.

[Maximus Nickus]

Originally posted by m_mike_k
I know it hasn' t, I have the side panel off a lot so I can see it. I am more cautious now ever since I burnt 2 1GHZ T-birds:(
Does ne1 know if +1.64V is the default for the cpu?

Default is 1.75V, maybe you have it set lower in the BIOS, but if its stable then good, LESS HEAT.

[Mike K]

Originally posted by Henry Rollins II
Some cpu HSF does not give the correct rpm signal. I had that problem with Zalman hsf a while ago, sometimes it showed 0 rpm, sometimes 15.000 rpm.

regards,
Henry.

sometimes mine does that too, it shows 33,000 rpm:eek:

[Maximus Nickus]

Powerstrip showed 9999999999999Mhz with wrong 8500 drivers!!!!!!

WOW:eek: