I was wondering if anyone else has seen this issue before. I previously had my voltages manually set for vcore around 1.28 for my overclock, then reverted back to stock voltages (defaults by bios) w/ EIST and C1E enabled.
Under the voltage settings it was stated that my default voltage would be set at 1.175 vcore. I didn't think much to check once I set everything back to defaults since before the bios update it was always correct.
Couple days later I noticed my temps were a little high, so I checked my voltage in windows and saw it was 1.5 vcore!!! I immediately rebooted into the bios and checked to see what was going on, everything was still set to default by bios vcore 1.175. Then checked PC Health in bios for voltage readings and it was 1.5 vcore!!! Only way I can get the vcore down to defaults is to manually set it.
Be warned I am sure this is an issue with the bios update, and if not has anyone else seen this.
Thanks -
Under the voltage settings it was stated that my default voltage would be set at 1.175 vcore. I didn't think much to check once I set everything back to defaults since before the bios update it was always correct.
Couple days later I noticed my temps were a little high, so I checked my voltage in windows and saw it was 1.5 vcore!!! I immediately rebooted into the bios and checked to see what was going on, everything was still set to default by bios vcore 1.175. Then checked PC Health in bios for voltage readings and it was 1.5 vcore!!! Only way I can get the vcore down to defaults is to manually set it.
Be warned I am sure this is an issue with the bios update, and if not has anyone else seen this.
Thanks -