Need WC'ing info, stats and numbers please!

[Aesik]

To continue on with the laminar and turblent discussion, I'd like to gather as much information about individual water cooling setups as possible. If you water cool, please take the time to fill out this brief survey.

What kind of waterblock do you use?
What are the fitting sizes of the water block, radiator and pump?
What are all your tubing diameters?
What kind of pump do you have and how many gph is it rated?
Have you ever measured your actual flow rate?
If so, what was your result and how did you measure it?
Do you use a reservoir?
Is your pump located in the reservoir?
If so, what is it's total volume? (minus the pump volume if possible)
What type of radiator are you using?
What are the sizes and number of fans on your radiator?
Are you using push, pull or push/pull with your fans and radiator?
Are your fans directly mounted to the radiator or are you using either a shroud or standoffs?
If using standoffs/shroud, how far away from the radiator is you fan?

Ok, so it's not so short :) Anyhow, this information would be very useful in helping me finish the follow-up article to the laminar and turbulence discussion. I think it would also be very interesting to get a good idea of where the water cooling community stands.

Thanks in advance for your help!

[The Overclocker]

i use a homemade direct die block

all the fittings are 3/8 inch

tubing is the same

my pump is a cheep pond pump (no name) rated at 800Lph (around 180GPH?)

nope, mut it will be quite hight with a lift height of 1.5M

i use a 2 liter res

the pump is in the res

i am using a dual fan res from becoling

i have 2 105 CFM 120mm ys-tech fans at 7 volts(sucking)

just fans one one side pulling

they are about 1 cm away due to space limitations i use standoffs

i recon it wopuld be usefull to put the temps in so the ambient is 20 and load and idle are the same at 24

[Diggrr]

Custom handbuilt, not like any other (really).
w/b-3/8 barb 3/8 npt, rad-3/8 barb 1/2 npt, pump-3/8 barb 1/2 npt
All tubing, 3/8 ID 5/8 OD 15 feet total length
Danner Supreme model 2 250GPH (946.25 lph)
No....5 foot head=far lower than rated
No way to check flow.
Reservior, Yes
Pump in res, No
Reservior capacity 1.3 liters
'88 Ford Taurus heater core (copper core)
1 x 120mm Panaflo L1a 12 volts (fan shroud cut from bong flange)
Fan arrangement, Pull
Aluminum shroud, box style
Fan distance from core, 1.5" (38mm)

Temps: CPU 25C/28C Case 30C/30C

[Voodoo Rufus]

Waterblock: Swiftech MCW-462 modded with 1/2" ID barbs.
All fittings and tubing is/are 1/2" ID.
Pump: Eheim 1048, 160gph
No flow rate numbers.
Reservoir: yes. Roughly .25L.
Pump is external, with the reservoir attached to the pump inlet.
Blackice Radiator.
1 Panaflo L1A 120mm at 10V pulling for now, was pushing.
Direct fan mounting.

Hope this helps.