Alucard
02-17-09, 04:21 PM
I am currently running my new rig that is in my sig, am just looking for some help getting my optimal stock settings right. I have done a lot of research and searching but am still unsure if there is a problem or not.
I went into bios and set the memory config to manual, and set the CAS, Trcd, and Trp to 5, and the Tras to 15.. leaving everything else on auto except the memory speed which i set to 1067 out of a few choices of preset speeds to choose from. Here is what CPUZ shows though...
http://i74.photobucket.com/albums/i264/HippieSlaya/spd.jpghttp://i74.photobucket.com/albums/i264/HippieSlaya/memory.jpg
Am I doing something wrong? Why does the SPD in CPUZ say that my max speed is 6400-400mhz?
The Corsair Dominator I have is supposed to be 1066 with 5-5-5-15 timings. All help and specific advice would be greatly appreciated. I'm not looking to overclock anything right now just getting everything to run as good as possible on stock settings.
I went into bios and set the memory config to manual, and set the CAS, Trcd, and Trp to 5, and the Tras to 15.. leaving everything else on auto except the memory speed which i set to 1067 out of a few choices of preset speeds to choose from. Here is what CPUZ shows though...
http://i74.photobucket.com/albums/i264/HippieSlaya/spd.jpghttp://i74.photobucket.com/albums/i264/HippieSlaya/memory.jpg
Am I doing something wrong? Why does the SPD in CPUZ say that my max speed is 6400-400mhz?
The Corsair Dominator I have is supposed to be 1066 with 5-5-5-15 timings. All help and specific advice would be greatly appreciated. I'm not looking to overclock anything right now just getting everything to run as good as possible on stock settings.