powercolor x1950pro 512mb ac

[ezcharlie]

guys, i have a few issues w/ this card.
but first off, does anyone know what the jumper is next to
the fan and pci-e power connector?
thanks.

[ezcharlie]

up

[Niku-Sama]

what are your issues other than this jumper.

[ezcharlie]

:-p.

my sys specs are in my sig,
when i had this running instead of the HD4850,
for some reason, my sys sometimes does not post.
no beeps. just power, leds and cpu fan speed going on high.
when this happens, what i would have to do is remove one of my ram chips.
then the sys gives a beep code like there was no VC installed.
if i can get my sys to do that, i just hit the reset button and the sys is fine.
once it gets into windows, i shut down, install the other mem chip again and 90%
of the time sys boots up fine. as long as it boots,
i can run games and use it even for a few days w/o rebooting.
when i shut it down though, sometimes it powers back up fine,
sometimes i have to repeat everything.
p.s. i noticed in 3dmark06, in the canyon test i get a few artifacts and the
sys normally would lock up. before the canyon test (airship) no artifacts.

after using the HD4850, none of these issues occur.