cold cathode inverter question...

[rUfUnKy]

I have a inverter for a 12" CC and have 4" CC...will this inverter put out way to much power for the 4" CC ..I don't want to start any fires ..;)

[pogue1000]

I like your new avatar.. what softwared did u use to make that? :)

[rUfUnKy]

Originally posted by pogue1000
I like your new avatar.. what softwared did u use to make that? :) Thanks..:) I used Adobe PhotoShop with EyeCandy, Image Ready, ms paint and Ulead Gif animator.

[WyrmMaster]

Originally posted by rUfUnKy
I have a inverter for a 12" CC and have 4" CC...will this inverter put out way to much power for the 4" CC ..I don't want to start any fires ..;)

Dont quote me on this, but shoudnt make any difference. Think about it, the same PSU can power a sytem that draws 100w and one that draws 300 just fine. Assuming the voltage is the same, which it shoud be, it wont be a problem.

[rUfUnKy]

Originally posted by WyrmMaster


Dont quote me on this, but shoudnt make any difference. Think about it, the same PSU can power a sytem that draws 100w and one that draws 300 just fine. Assuming the voltage is the same, which it shoud be, it wont be a problem. Well I hooked it up and it works. I had it on for about ten min. and it seemed fine...I figure the worst that would happen would be I blow the bolb...Its on a rocker switch so it wont be on all the time anywho..:D

[mw521]

Yeah, shouldn't make any difference, however, I hereby state that I am not responsible for any taking my advice and blowing up something. But it won't.:beer: