Need help, please!

[Morbid]

I have a XP 1800+ AGKGA "Y" sitting at 1.75GHz right now. This being done by pushing my Crucial 256mb PC2100 DDR to 3.0v. Is this good? They feel warm to the touch.. not hot in anyway. Should I run it that high? I been doing Sandra's burn-in for about 10 mins and the load temp has evened out to about 39c.

Any and all comments would be appreciated! :confused:

[TranceBear]

Originally posted by Morbid
I have a XP 1800+ AGKGA "Y" sitting at 1.75GHz right now. This being done by pushing my Crucial 256mb PC2100 DDR to 3.0v. Is this good? They feel warm to the touch.. not hot in anyway. Should I run it that high? I been doing Sandra's burn-in for about 10 mins and the load temp has evened out to about 39c.

Any and all comments would be appreciated! :confused:

I might get some Ram-sinks if they are warm/hot. Great O/C!!

[Morbid]

Ahh.. it didn't last that long. Locked up a little while after. Back down to 2.8v on DDR... CPU @ 1.72GHz. 41c full load with case closed up. 1 intake, 1 exhaust.. 2 if you count PSU. Un-altered Antec SX1035B. Guess it's ok that it's at 41c full load while folding... ambient temp is 32c :(

Oh well.. will have to stick with it until I get water-cooled.
Thanks!

[Dissolved]

Originally posted by TranceBear


I might get some Ram-sinks if they are warm/hot. Great O/C!!

agreed, u could look on ebay for heat spreaders there about 7 bucks and will help u gain a bit more stable..
and adding side/top blowhole fans will deffinatly help case temps, 32c is very high... 28c is about the highest id wanna go.