Connecting the Vcore bridges on the XP

[Fiz]

I was wondering if you should fill in the pits on those ones too. I want mine to default to 1.85 volts. The reason I ask is because it took 3 hours for me to get the L1's done, I really don't want to spend another 3 doing this. If they do have to be filled in, too bad for me :) TIA

Fiz

[Fiz]

Oh well, I guess I will just try it and see what happens.

Fiz

[Maximus Nickus]

Can't your board change the VCore within the BIOS?

U don't want to short your chip by connecting the wrong stuff!!!

[Fiz]

I can change it in the bios, but i need like 1.88 or 1.89 Vcore to get it 100% stable @ 1600MHZ. Right now it will crash after running burnk6 for about 2 hours. I have read that if you make the proc default to 1.85 and then set the Vcore in bios up to 1.85, you can sometimes get that teenie bit extra.

Fiz

[The Coolest]

If I remember correctly the vcore bridges are the L11 on the XP...
Only a reminder

[Maximus Nickus]

Originally posted by Fiz
I can change it in the bios, but i need like 1.88 or 1.89 Vcore to get it 100% stable @ 1600MHZ. Right now it will crash after running burnk6 for about 2 hours. I have read that if you make the proc default to 1.85 and then set the Vcore in bios up to 1.85, you can sometimes get that teenie bit extra.

Fiz


It won't make a difference, once the default VCore is set to 1.85V then u won't be able to change it in the BIOS unless you want less voltage of course.

Ask Doc about a volt mod.