It's ALIVE!!!!!!

[Bonka]

YES!!!!

Finally got my board back. My partially lapped heatsink is on, no thermal paste. Booted up. Went straight to 1.5 (125fsb) with dividers at 1/4. Voltage at 1.6. Booted up fine. Went to motherboard monitor. I see 30c for cpu and it's stable :D hahahahah, this is so awesome. I'll be lapping some more tomorrow and will apply some arctic silver ii once I jack some my friend.

So happy=) :D :D :D

Strange thing though, my rmaed board wasn't even repaired or replaced. They said it was fine. Whateever,

[deez]

you should not have your CPU running very long without thermal paste or at least a thermal pad. if you need to just go to radio shack and pick up a tube of heat sink compound for $2

[Bonka]

Hmmmm, this is my temp at load right now. I just applied some arctic silver ii on my partially lapped heatsink. CPU temps range from 32-33c.

http://www.bonka.f2s.com/images/mbmtemp2.jpg

Is it suppose to be this low??? I'm not use to these low temps just yet.


:eek:

[Sempei]

Originally posted by Bonka
Hmmmm, this is my temp at load right now. I just applied some arctic silver ii on my partially lapped heatsink. CPU temps range from 32-33c.

http://bonka.asp2.net/images/mbmtemp2.jpg

Is it suppose to be this low??? I'm not use to these low temps just yet.


:eek:

Those temps aren't bad. I idle at 33-34 @1.75v using a Glaciator II.

[Flu!d]

Good to hear that you seem to have it all sorted out now Bonka!!

Good luck!

[6502kid]

Those are good temps for a Tualatin.

About what I get for both mine with the default sinks.

I got a mutant now with a .50amp 7000rpm fan out
of a Dragon Orb 3 screwed to a coolermaster aluminum
hs. Got temp at 28c at full load, 25c at idle. (19c in the room)

This is at 128fsb, 1.50v with a 1.1A

[Bonka]

Thanks guys. I'll see if my temps go down any further with more lapping :)

[tainice]

yea..lapping will do more good than anything else..:D ok, maybe not EVERYTHING, but lets just say, a well lapped sk6 is on par with a freaking expensive swiftech... after 40 min of lapping on my gladitor, temp drops 2C..cannot imagine if do the whole set from 400~1500..come people, let's get lapping!!

[Bonka]

I'll be lapping some more tonight. Anyways, I was wondering why my idle and load temps vary so little? Is it the nature of how Tualatin's perform? Perhaps I need to reapply that asii or I need more lapping? Here are my load temps right now burning in for several hours (case open)

http://www.bonka.f2s.com/images/mbmtemp3.jpg

:D

[Sempei]

Originally posted by Bonka
I'll be lapping some more tonight. Anyways, I was wondering why my idle and load temps vary so little? Is it the nature of how Tualatin's perform? Perhaps I need to reapply that asii or I need more lapping? Here are my load temps right now burning in for several hours (case open)

http://www.bonka.f2s.com/images/mbmtemp3.jpg

:D
Must be the chips. My load temp only goes up about 3C from my idle temp.