Celeron 667@1000 some problems

[DirT]

My problem is that when i play games in open gl my system hungs up after a few sec (except q3arena engine games), in d3d everything is stable how can i fix it
i have dets 23,11 but it happends on all drivers
is there a way to have biger voltage than mainboard supports my abit be6 gives only 1,85 maybe this is a problem

[batboy]

If that BE6 has the Soft Menu II BIOS, then there is a BIOS flashing trick you can do to get higher voltage settings. Do a search on how to do it, since I don't remember the exact details off-hand right now.

[Rooster]

if your runnig a slotket set it to a higher volt bye the junpers. then your bios will have more options

[DirT]

Originally posted by batboy
If that BE6 has the Soft Menu II BIOS, then there is a BIOS flashing trick you can do to get higher voltage settings. Do a search on how to do it, since I don't remember the exact details off-hand right now.

well i search everywhere but i havet find description of the trick if it is no problem try to focus and help me to fint it

thx

[deez]

sounds like a vid card issue not a CPU issue....perhaps this is posted in the wrong section

[DirT]

http://www.anomaly.org.au/bh6faq/FAQ/faq.html#3

i found it is this the trick??

[batboy]

Yes, that is the BIOS flashing trick in that link you posted. Also, Rooster made a very good suggestion that I had overlooked. Set the voltage jumpers on the slotket to a slightly higher setting. That should fool your BIOS into thinking the default voltage of your CPU is higher, thus allowing you higher voltage setting options in the BIOS.

[deez]

he said it was only in open gl mode that it locks up so it doesn't sound like it has anything to do with the CPU to me

[DirT]

well it doesn't work with voltage jumpers my mb gives always as defoult 1,65 and i thin it's somethin with cpu becourse at 833 it goes without problems on that open gl games an at 1ghz it makes trouble