- Joined
- Jun 10, 2009
Hi, I am a newbie at overclocking, but I would like to achieve an overclock of 3.8 Ghz.
My CPU and RAM are:
Core2Quad Q9550
OCZ Reaper HPC 4GB (2 x 2GB) DDR2 1066 (PC2 8500)
I am currently running at 3.4 Ghz nice and stable. It's set at 1.175 Vcore with all the other voltages at default, and I didn't touch the advanced BIOS settings.
I'm still very new to this overclocking process, so I would appreciate any help of reaching 3.8.
Thanks
My CPU and RAM are:
Core2Quad Q9550
OCZ Reaper HPC 4GB (2 x 2GB) DDR2 1066 (PC2 8500)
I am currently running at 3.4 Ghz nice and stable. It's set at 1.175 Vcore with all the other voltages at default, and I didn't touch the advanced BIOS settings.
Code:
*************************************************
Robust Graphics Booster [Auto]
CPU Clock Ratio[8]
Fine CPU Clock Ratio [.5]
*********Clock Chip Control*************************
CPU Host Clock Control [Enable]
CPU Host Frequency (Mhz) [400]
PCI Express Frequency (Mhz) [100]
C.I.A 2 [Disable]
*********Advanced Clock Control*********************
CPU Clock Drive [700]
PCI Express Clock Drive [700]
CPU Clock Skew [Default]
MCH Clock Skew [Default]
*********DRAM Performance Control******************
Performance Enhance [Standard]
Extreme Memory Profile (XMP) [Auto]
(G) MCH Frequency Latch [400]
System Memory Multipler [2.66D]
Memory Frequency [1066]
DRAM Timing Selectable [Manual]
CAS Latency Time [5]
tRCD [5]
tRP [5]
tRAS [15]
*********Advanced Timing Control*********************
tRRD [Auto/Default]
tWTR [Auto/Default]
tWR [Auto/Default]
tRFC [Auto/Default]
tRTP [Auto/Default]
Command Rate (cmd) [Auto/Default]
*********Motherboard Voltage Control******************
Load-Line Calibration [Disable]
CPU Vcore [1.2500]
CPU Termination [Default]
CPU PLL [Default]
CPU Reference [Default]
MCH Core [Default]
MCH Reference [Default]
MCH/DRAM Refernce [Default]
ICH I/O [Default]
ICH Core [Default]
DRAM Voltage [2.1000]
DRAM Termination [Default]
Channel A Ref [Default]
Channel B Ref [Default]
I'm still very new to this overclocking process, so I would appreciate any help of reaching 3.8.
Thanks