- Joined
- Jan 15, 2004
My last oc'ed system was a P4 2.4ghz running at 4ghz On Air, that was the time when I first joined this forum. That system is still running and is with my brother Anyway, Today, I decided to go back oc'ing.
My rig is on my sig and these are my settings :
My system didn't boot up at cpu vcore 1.36500V. After I changed it to 1.37500V, system booted. I have been browsing while burning dvd while watching a movie, and playing wow at the same time and I haven't gotten any errors. Below is my temp results.
http://img44.imageshack.us/i/tempsq.jpg/
Q's:
I haven't run prime 95. How many prime 95 should I be running? 2 instances?
Is there another testing software I should be running?
Are my settings okay?
Are my temps acceptable?
Any suggestions would be greatly appreciated Thank you.
My rig is on my sig and these are my settings :
Code:
*************************************************
Robust Graphics Booster [Auto]
CPU Clock Ratio [8x]
(8x400 = 3.6Ghz)
*********Clock Chip Control*************************
CPU Host Clock Control [Enabled]
CPU Host Frequency (Mhz) [400]
PCI Express Frequency (Mhz) [Auto]
C.I.A 2 [Disabled]
*********Advanced Clock Control*********************
(These are default settings, didn't touch them)
CPU Clock Drive [800mV]
PCI Express Clock Drive [900mV]
CPU Clock Skew (0ps) [Default]
MCH Clock Skew (0ps) [Default]
*********DRAM Performance Control******************
Performance Enhance [Turbo]
(G) MCH Frequency Latch [Auto]
System Memory Multipler [2.66D]
Memory Frequency (SPD 1066) [1066]
DRAM Timing Selectable [Manual]
CAS Latency Time [5]
tRCD [5]
tRP [5]
tRAS [18]
*********Advanced Timing Control*********************
(Values)
tRRD [Auto] (4)
tWTR [Auto] (4)
tWR [Auto] (8)
tRFC [Auto] (72)
tRTP [Auto] (4)
Command Rate (cmd) [Auto] (0)
*********Motherboard Voltage Control******************
Load-Line Calibration [Enabled]
CPU Vcore (1.27500V) [1.37500V]
CPU Termination (1.200V) [Normal]
CPU PLL (1.500V) [Normal]
CPU Reference (0.760V) [Normal]
MCH Core (1.100V)[Normal]
MCH Reference (0.760V) [Normal]
MCH/DRAM Refernce (0.900V)[Normal]
ICH I/O (1.500V)[Normal]
ICH Core (1.100V) [Normal]
DRAM Voltage [1.8000V]
DRAM Termination (0.900V) [Normal]
Channel A Ref (0.900V) [Normal]
Channel B Ref (0.900V) [Normal]
*************************************************
My system didn't boot up at cpu vcore 1.36500V. After I changed it to 1.37500V, system booted. I have been browsing while burning dvd while watching a movie, and playing wow at the same time and I haven't gotten any errors. Below is my temp results.
http://img44.imageshack.us/i/tempsq.jpg/
Q's:
I haven't run prime 95. How many prime 95 should I be running? 2 instances?
Is there another testing software I should be running?
Are my settings okay?
Are my temps acceptable?
Any suggestions would be greatly appreciated Thank you.
Last edited: