FSB:DRAM

[ciku]

I am running a Q6700 2.66 @ 3.2 with x8 multiplier and ram at 2.66D
Cpu-z says Dram Freq is 533mhz and FSB:DRAM at 3:4. How can I run it at 1:1?

EDIT: Cpu-Z Pix Here. (http://yfrog.com/16cpuzij)

[Neuromancer]

lower your mem divider to 266 instead of 400

[ciku]

lower your mem divider to 266 instead of 400

Ty for reply. But if I actually put it at 266, 8x266 = 2.128ghz which is under clocking my cpu, so it has to be 400 :(

[deadlysyn]

Actually, to get to 1:1, on that Gigabyte board, the memory divider should be set to 2.00. As far as I remember, 2.00B will get you at 800 for your memory speed, which would be 1:1, while 2.00D will put it at 1600, which your memory may not run at. I would have to check my BIOS again to verify this, and I am away from my rig ATM. Once I get a chance to get to my rig, I will post back up, unless someone else can confirm or correct this.
Also, OP, YGPM.

[ciku]

Actually, to get to 1:1, on that Gigabyte board, the memory divider should be set to 2.00. As far as I remember, 2.00B will get you at 800 for your memory speed, which would be 1:1, while 2.00D will put it at 1600, which your memory may not run at. I would have to check my BIOS again to verify this, and I am away from my rig ATM. Once I get a chance to get to my rig, I will post back up, unless someone else can confirm or correct this.
Also, OP, YGPM.

Right now, i'm running at 2.66D which is 1066, if I run it at 2.00B that would be under clocking my ram right?

Also, just updated bios to F11, after rebooting, it reset all the settings so I reconfigured it and when it booted, it had errors and ran at stock speed. Then I rebooted again, reset all bios config and reconfigured again, now it booted successfully... kinda weird, hehe, didn't change any setting.

[redduc900]

Here's each memory multiplier and what MCH straps they're on...