How do you set this up

[Wicked Klown]

Ok I bought the DigiDoc 5. My ? is how do I get it to stay on one temp instead of scanning all of them. I could care less about the rest of the temps. I just want to know the temp of my CPU at all times.

[Wicked Klown]

*bump*

[nodoze]

I don't have a DD5, but somebody mentioned in an earlier thread that all you have to do is push the buttons on the front of the DD5 so that the temp your interested in is displayed. The display should not return to the "scanning" mode. Good Luck.

[SRB442]

Setting up the digi 5 is a little tricky for me. I have one installed and you have to push the lower right button down when you are on the temp you want to watch. I have not got this down perfect yet. The amount od time uou hold the button makes a difference to staying on one temp or scanning temps or checking temps and fan speeds. I printed out the manual and if I remember right there was not a option to monitor one temp but it will do that.
Steve

[Wicked Klown]

I found out last night how to do it. All you do is push the arrow up or down til you get it where you want it then push scan. So far it`s worked for me. The manual was not a big help.

[Yodums]

Originally posted by Klownin79
I found out last night how to do it. All you do is push the arrow up or down til you get it where you want it then push scan. So far it`s worked for me. The manual was not a big help.

Sounds easy enough. :) Glad it worked :D