- Joined
- Feb 20, 2009
- Location
- Sacramento, Ca
Hello all,
I know that this topic has been beaten and beaten but I haven't been able to find any comparative reviews of push/pull with fans at lower CFM vs. push with fans at higher CFM. After reading reviews from skinnee, I know that push/pull adds about 20-30% performance increase. Now my question is, do you guys think 6 yate loon mediums (33dBa, 70CFM) undervolted in push/pull would work better, and not be as loud, than 3 higher CFM fans.
Essentially, I'm wondering how much more noise is created by adding 3 more fans to make push/pull to get the 20-30% increase in performance.
Any ideas or help will be greatly appreciated.
BTW, I'm sure that these results are across the board on radiators, but if not, I am using an XSPC RX360.
I know that this topic has been beaten and beaten but I haven't been able to find any comparative reviews of push/pull with fans at lower CFM vs. push with fans at higher CFM. After reading reviews from skinnee, I know that push/pull adds about 20-30% performance increase. Now my question is, do you guys think 6 yate loon mediums (33dBa, 70CFM) undervolted in push/pull would work better, and not be as loud, than 3 higher CFM fans.
Essentially, I'm wondering how much more noise is created by adding 3 more fans to make push/pull to get the 20-30% increase in performance.
Any ideas or help will be greatly appreciated.
BTW, I'm sure that these results are across the board on radiators, but if not, I am using an XSPC RX360.